R3 Electric strike interlock version 12V - for tighten door

Note

The R3 Electric Strike is designed for remote opening of left, right (if construction of door frame allows it), and double-wing doors and gates. It is designed to be installed within a doorframe, in which it is possible to make a 23x29x91 mm mounting hole (draw on the right).
The lock was made smaller, to the dimensions as indicated, by using a leverage system, thanks to which most doorframes can accommodate our locks.

The R3 Electric Strike can work together with home interphone installation in all types of an entrance door. It is made of rust proof zinc alloys. It can be installed externally, provided that it is protected against flooding, against hostile weather impacts, and against being covered with paint. Additional plate is required for mounting.

Electric strike version

The interlock version - acts in the same way as the basic version, but has an additional ratchet interlock function, thanks to which, when the interlock lever is moved, the door is left open permanently, without the use of an electronic pulse. When the interlock lever is moved back to its original position, the lock works as in the basic version.
This version may be used in rooms, where temporary unblocking of the door may be sometimes needed within working hours, i.e.: in office or services areas. When working hours are over, it is possible to block the lock again, whereby access to the premises is controlled by means of an interphone set system.

For tighten door - at constant pressure on the door (e.g. by wind power, door seal, etc.) about 5-15 kg on the lock bolt, electric strike can open the door, in contrast to Electric strike - basic version.

When working, the lock gives out a low, humming noise.

Basic technical data

external housing dimensions:	20 x 28,5 x 90 mm
weight:	0,20 kg
allowable thrust on the door at ratchet release:	30N (3 kG)
allowable load of the door impacting the lock:	3000 N (300 kG)
rated voltage U:	10 ± 2V *
allowable uninterrupted operation time:	30 min.
ratchet:	adjustabele within the range of 3 mm, which allows for door clearance adjustment
* with bell transformer

Current consumption

Voltage U	8V	10V	12V	8V	10V	12V
Electric strike version	Alternating Current (AC) [mA]			Direct Current (DC) [mA]
R3-12.26L	320	500	620	680	800	950

Determining left- and right-hand doors

The door should be determined from the side of hinges are visible.

Documentation

R3 Electric strikes meet the essential requirements of the EMC Directive 2004/108/WE.

Product code: R3-12.26L